How To Repair Plaster Cornice In Some Easy Steps?
It is usually regarded by many as an oxymoron and the common or gut feeling that people have been that it is impossible repairing cornice plaster walls. Although, this fact may be partially correct because, it is not impossible, repairing cornice plaster walls but is a difficult task. This is true in a case of badly damaged walls. The most common thing that people usually do with cracked plaster walls is that they tear the damaged chunk, and this will lead to the remaining part of the plaster wall dropping down one chunk after the other. It is always advisable to preserve whatever is left instead of trying to tear the whole thing off and getting it redone. Below is the method to help Cornice plaster wall repair.
- The moment a crack is noticed, the first and foremost thing is to be done to smoothen out the broken part of the wall by scraping the edges of the crack. This is usually done with the help of an ordinary kitchen knife. The knife is used to score the interior part of the cracked edges. After scraping the sides of the crack from within, any loose crumbs need to be brushed off.
- In the process of cornice plaster walls repairing, the next job would be to apply a thin layer of joint compound over the damaged area that was smoothened. This can be done with the help of a wide taping knife.
- After applying the compound to the damaged part, a paper tape or a fiberglass tape needs to be pressed into the same. After this, it is left out to dry for a little while.
- It is necessary to join the joint compound over the area on which the tapes have been pressed to ensure that the complex extends a couple of inches beyond the area that has been taped.
Once the joint compound is dried almost, you are ready for the next step in repairing plaster cornice. With the help of fine sandpaper, it is slightly sand down to avoid any ridges or bumps on the wall that may be caused while applying the joint compound. Care needs to be taken while using the sandpaper to sand down the natural compound as it may so happen that the taped area gets dug while doing so.
After the fixed area is sand down using the sandpaper, a second coating of the joint compound is applied to the damaged part by repeating all the above steps of the plaster wall repair process.
However, with fixing plaster cornice, one important thing that is to be done while applying the joint compound for the second time is that the application is extended by a few more inches, almost six to eight inches beyond the taped area.
Now the next step is to leave the wall dry completely. Even this time, the wall needs to be sanded down with sandpaper to remove any ridges or bumps of the joint compound.
Once the second coating of the joint compound dries completely, a final coat of the same is to be applied by following the same procedure as described above. Now, this time, with the repairing Cornice plaster walls processes the application of the joint compound is extended to approximately twelve inches. As this the last and final time that the coat is being applied, sanding needs to be done properly to give a smooth finish to the wall.
Now, you are done with the repairing plaster walls. You are now ready to enjoy the finish you have just got spending a little time repairing the Cornice plaster walls.
Cornicedesigns.co.uk - Manufacturer, installer and supplier of ornamental and decorative plasterwork in UK, has a broad range of decorative plaster mouldings, plaster cornice, coving and other profiles for ceiling roses and fireplace surrounds. Call: 01709 431446 or visit: cornicedesigns.co.uk